Air Conditioner Remote Control Set Method

- Aug 10, 2017 -

Air Conditioner Remote Control Set method

method one

Artificially enter the code

1, manually open the air conditioner power, from the "code table" to find out the air conditioner you want to remote control the corresponding model, and find the first code.

2, press and hold the "set" button (about 3 seconds), wait for the model code in the window when the flashing, press the "temperature +" or "temperature -" key until the required code displayed on the window and flash, If the code is normal, the air conditioner will turn on.

3, press the "Finish" button, the model code to stop blinking.

4, test the remote control button is valid, valid, set up, invalid, repeat steps 2-3.

Artificial search code

1, manually open the air conditioner power supply, the remote control to the air conditioner to close the window.

2, hold down the "set" button (about 3 seconds), wait for the model code in the window when the flashing, press the "temperature +" button, until the air conditioner automatically open.

3, press the "complete" button, set up.

Automatically search for code

1, manually open the air conditioner power, the remote control to the air conditioner to receive the window.

2, press and hold the "set" button (about 6 seconds), wait for the code in the display changes (+1) when the release, then enter the speed search for model status, pay attention to your air conditioner status, Until the air conditioner is automatically turned on, press the "Finish" button to stop the search.

3, check the button function is correct, (except temperature +, -, timer on / off, set the key), if correct, the code is valid, press the "complete" button, set up. If it is not correct, press the "Setup" button to continue the search.

Applicable Model:

K-100S K-9098 K-808 K-818 K-838 K-880 K-

Method Two

Manual search

1, manually open the air conditioner power supply.

2, from the "code table" to find you want to remote control of the air conditioner corresponding to the model code.

3, click the "Settings" button, until the required code displayed on the window and flash.

4, press the "confirm" button, the model code will stop flashing.

5, test the remote control button is valid, valid code is set up correctly, invalid is to try other code, repeat steps 2-4.


Previous:Remote Control Performance Of The Remote Control Next:Week Of Conservation: We Can Do This